2N Access Unit - Mobile Key

2N Access Unit Configuration Manual
90 / 134
5.4.2 Mobile Key
The2NAccess Unitequipped with the Bluetooth module allow for user authentication via the
2N
®
Mobile Keyapplication available to devices with iOS 12 and higher (iPhone 4 s and higher
phones) or Android6.0 Marshmallow and higher (Bluetooth 4.0 Smart supporting phones).
User Identification (Auth ID)
The 2N
®
Mobile Key application authenticates itself with a unique identifier on the 2NAccess
Unitside:Auth ID(128-bit number) is generated randomly for every user and paired with the
2NAccess Unituser and its mobile device.
You can set and edit the Auth ID value for each user in the Mobile Key section of the 2NAccess
Unitphone book. You can move Auth ID to another user or copy it to another intercom. By
deleting the Auth ID value you can block the user's access.
Encryption Keys and Locations
The 2N
®
Mobile Key–2NAccess Unitcommunication is always encrypted. 2N
®
Mobile
Keycannot authenticate a user without knowing the encryption key. The primary encryption
key is automatically generated upon the 2NAccess Unitfirst launch and can be re-generated
manually any time later. Together with AuthID, the primary encryption key is transmitted to the
mobile device for pairing.
•
Note
The generated Auth ID cannot be saved in more mobile devices than one. This
means that Auth ID uniquely identifies just one mobile device or its user.
