2N Access Unit - 2 N Access Unit Configuration Manual; ;

2N Access Unit Configuration Manual
55 / 134
•
•
•
•
•
•
•
Prefer Icons to Text–the icons on the dosplay will be preferred to the text.
Power Saving Mode–activate the power saving mode in which the display brightness is
reduced. If no event occurs during two Slideshow screen activation timeouts, the power
saving mode activation has been successful. Set 0 in the Slideshow screen activation
timeout to disable the power saving mode. Any movement in front of the intercom camera
or any display event (such as door lock activation or display touch) restores the full
brightness of the display.
Showcase Mode– set whether the device shall go into the showcase mode when idle.
Choose various options in the showcase mode (Slideshow, Company Logo, Address).
Delay of Showcase Mode Activation–set the idle timeout in the range of 1 to 600 seconds
after which the device goes into the mode of representation.
Original Language–download the localisation file template for own translation. It is an
XML file with all the texts to be displayed.
Custom Language–remove, download and upload a localisation file of your own.
Slideshow
This tab helps you configure a list of images to be displayed in the Slideshow mode. Upload up
to 8 images to be shown with a preset delay.
Slideshow Transition Time–set the image displaying time in a slideshow.
•
•
•
•
•
Note
If none of the pre-defined languages is convenient for you, proceed as follows:
Download the original language file (English).
Modify the file using a text editor (replace the English texts with your own ones).
Upload the modified localisation file to the intercom.
SetLanguage Settings | LanguagetoCustom.
Check and correct if necessary the texts on the intercom display.
