2N Access Unit - 2 N Access Unit Configuration Manual; ;

2N Access Unit Configuration Manual
66 / 134
•
•
•
•
•
•
Associated Switch–set the switch to be activated after user authentication via this
module. If you set Door Lock Switch, the authentication rules specified in Hardware / Door
will be used.
Allowed Card Types– set the type of a card to be accepted by the card reader. The card
reader supports just one card type at an instant.
Forward to Wiegand Output– set a group of Wiegand outputs to which all the received
RFID card IDs will be resent.
13.56 MHz Card Reader Module Configuration
Module Name– set the module name for card reader logging purposes.
Door–set the reader direction(Door Entry, Door Exit) for the Attendance system
purposes.
Associated Switch–set the switch to be activated after user authentication via this
module. If you set Door Lock Switch, the authentication rules specified in Hardware / Door
will be used.
•
Tip
To accelerate card reading, you are recommended to select the card types used by
the user in the module settings.
