2N Access Unit - 2 N Access Unit Configuration Manual; ;

2N Access Unit Configuration Manual
88 / 134
•
•
•
•
1.
2.
3.
Send to E-Mail Address– set e-mail sending. The following options are available:
Device Rebooted
Tamper Switch Activation

Device Restart Message–set the message to be sent to the specified e-mail address whenever
the device is restarted.
Subject– set the e-mail subject to be sent.
E-Mail Body– edit the text to be sent. Use the HTML formatting marks in the text.You can
insert special symbols substituting the username, date & time and device ID.These
symbols will be replaced with the actual value before sending. Refer to the table of
substitute symbols below:
$User$ Called username
$DateTime$ Current date and time
$DeviceName$ Intercom identification
If the placeholder value is not found in the string, the value is used directly.
