2N Access Unit - 2 N Access Unit Configuration Manual; ;

2N Access Unit Configuration Manual
42 / 134
Tip
In case of use external relay part no.: 9137410E are used next HTTP commands:
To turn on the switch –http://ip_address/state.xml?relayState=1(e.g.:http://
192.168.1.10/state.xml?relayState=1)
To turn on for pre-defined time (default value is 1.5 s) –http://ip_address/state.xml?
relayState=2(e.g.:http://192.168.1.10/state.xml?relayState=2)
To turn off –http://ip_address/state.xml?relayState=0(e.g.:http://192.168.1.10/
state.xml?relayState=0)
In case of use external relay part no.:9137411Eare used next HTTP commands
(SymbolX should be replaced with a number of the desired switch):
To turn on the switch –http://ip_address/state.xml?relayXState=1(e.g.:http://
192.168.1.10/state.xml?relay1State=1)
To turn on for pre-defined time (default value is 1.5 s) –http://ip_address/state.xml?
relayXState=2(e.g.:http://192.168.1.10/state.xml?relay1State=2)
To turn off –http://ip_address/state.xml?relayXState=0(e.g.:http://192.168.1.10/
state.xml?relay1State=0)
