2N Access Unit - 2 N Access Unit Configuration Manual; ;

2N Access Unit Configuration Manual
76 / 134
•
•
•
•
•
•
•
•
•
•
•
Module Name– set the module name for card reader logging purposes.
Door–set the reader direction (Not specified, Arrival, Departure) for the Attendance
system purposes.
Associated Switch–set the switch to be activated after user authentication via this
module. If you set Door Lock Switch, the authentication rules specified in Hardware / Door
will be used.
Allowed Card Types– set the type of a card to be accepted by the card reader. The card
reader supports just one card type at an instant.
Samsung NFC Compatibility–enable NFC compatibility with the Samsung phones.
Forward to Wiegand Output– set a group of Wiegand outputs to which all the received
RFID card IDs will be resent.
Touch keypad (serial number)
Module Name–set the module name for logging events from the touch keypad module.
Door–set thereader direction (Door Entry, Door Exit) for the Attendance system
purposes.
Blink at Keystroke– setkeystroke light signalling for noisy environments where acoustic
signals are difficult to hear.
Forward to Wiegand Output– seta group of Wiegand outputs to which all pressed keys
are to be forwarded.
Transmitted Code Format– select a 4bit or 8bit (higher security) format for the codes to
be transmitted.