2N Access Unit - 2 N Access Unit Configuration Manual; ;

2N Access Unit Configuration Manual
60 / 134
•
•
•
If the function is enabled, all the switches get blocked for 30 minutes whenever the tamper is
activated. Blocking is active even after the device restart. Each port can be controlled
viaAutomation. Press theUNBLOCKbutton, disable the function or reset the configuration
factory values to unblock the switches.
Assigned input–select the logical input to which the tamper switch is to be
connected.TamperSwitchActivatedsignals the tamper switch activation.
Enable automatic switch blocking– block the switches by tamper activation for 30
minutes.
Switch blocking state–display and make switch blocking settings.
•
•
Note
From PCB version 599v2 up, each of the models is equipped with an optical tamper
switch.
From PCB version 599v2 up, the assigned input is indicated by a module pictogram
backlight. In lower PCB versions, it is indicated by the LED light on the right-hand
module side.

•
•
•
Note
Menu Digital Inputs is available for models:
2N
®
IP Verso
2N
®
IP Varioand 2N
®
IP Force if an internal card reader is installed
2NAccess Unit
