2N Access Unit - 2 N Access Unit Configuration Manual; ;

2N Access Unit Configuration Manual
87 / 134
•
•
a.
b.
c.
d.
e.
f.
Subject– set the e-mail subject to be sent.
E-Mail Body– edit the text to be sent. Use the HTML formatting marks in the text. You can
insert special symbols substituting the username, date and time, intercom/card
identification, Bluetooth/fingerprint identifier and identifier validity for information. These
symbols will be replaced with the actual value before sending.See the list of placeholders
below:
$User$ Called username
$DateTime$ Current date and time
$AuthId$ User authentication ID
$DeviceName$ Intercom identification
$AuthIdType$ Authentication type – define the identifier source (Card, Bluetooth or
Fingerprint)
$AuthIdValid$ Identifier validity –valid for a valid identifier, Invalid for an invalid
identifier
An extended syntax can be used for the $AuthIdType$ and $AuthIdValid$ placeholders to
replace the values in different languages.
If the placeholder value is not found in the string, the value is used directly.
E-Mail on Event
Set that an e-mail shall be sent whenever the SIP gets lost, the device is rebooted or the tamper
switch is activated on the device.