2N Access Unit - 2 N Access Unit Configuration Manual; 4. Signalling of Operational Statuses; ;

2N Access Unit Configuration Manual
8 / 134
4. Signalling of Operational Statuses
2NAccess Unitgenerates sounds to signal changes and switching of operational statuses. Each
status change is assigned a different type of tone. See the table below for the list of signals:
Tones Meaning
User activated
This tone signals entering of the user activation code. The activation
code is used for user (user’s position) activation. Refer to the Users
subsection for the activation code settings.
User deactivated
This tone signals entering of the user deactivation code. The
deactivation code is used for user (user’s position) deactivation. Refer
to the Users subsection for the deactivation code settings.
Profile activated
This tone signals profile activation. This function helps enable alerting
of a user group in an office, for example. Refer to the Profile subsection
for the activation code settings.
Profile deactivated
This tone signals profile deactivation. Refer to the Profile subsection
for the deactivation code settings.
Internal application launched
The internal application of the 2N Access Unit is launched upon the 2N
Access Unit power up or restart. A successful launch is signaled by this
tone combination.
Connected to LAN, IP address received
2N® Access Unit logs in upon the internal application launch. A
successful LAN login is signalled by this tone combination.
•
Note
Signalling of some of the above mentioned statuses can be modified; refer to the
User Sounds subsection.
