2N Access Unit - 2 N Access Unit Configuration Manual; ;

2N Access Unit Configuration Manual
86 / 134
•
•
•
•
ClickApply & Testto send a testing e-mail to the defined address with the aim to test the
functionality of the current e-mail sending setting. Enterthe destination e-mail address into the
Test e-mail address field and press the button.The current e-mail sending state is continuously
displayed in the window for you to detect an e-mail setting problem if any on the intercom or
another network element.
E-mail on Access
Set that an e-mail shall be sent whenever an RFID card is tapped on the card reader and/or
Bluetooth/fingerprint reader identification is made.
Send E-Mail at– set e-mail sending. The following options are available:
Do Not Send E-mail–no e-mail message will be sent.
All Accesses–an e-mail will be sent at all (valid/invalid) access attempts.
Denied Accesses–an e-mail will only be sent if the access is denied.
