2N Access Unit - 2 N Access Unit Configuration Manual; ;

2N Access Unit Configuration Manual
22 / 134
•
•
•
•
•
•
•
•
Switch1–2– set a private user switch activation code: up to 16 characters including digits 0–9
only.The code must include at least two door unlocking characters via the intercom keypad and
at least one door unlocking character via DTMF.
Each of the intercom users can be assigned two access RFID card.
Card ID– set the user access card ID: 6–32 characters including 0–9, A–F.Each user can be
assigned up to two access cards.When a valid card is tapped on the reader, the switch
associated with the card reader gets activated. If the double authentication mode is
enabled, the switch can only be activated using both a card and numeric code.
Virtual card ID– set the user virtual card ID for user identification in the devices that are
integrated with the2N IP intercomsvia a Wiegand interface. Each user can be assigned
just one virtual card. The virtual card ID is a sequence of 6–32 characters: 0–9, A–F. After
the user is validated via the Bluetooth/biometric reader, the identifier is sent to the device
integrated with the2N IP intercomvia Wiegand.
Auth ID– set a unique mobile device/user identifier. The parameter value is automatically
generated for pairing. You can move Auth ID to another user or copy it to another device in
the same location.
pair via USB reader
pair via this device
delete Auth ID
Pairing state– display the current pairing state (Inactive, Waiting for pairing, PIN validity
expired or Paired).
Pairing valid until– display the date and time of the generated authorisation PIN validity
end.