2N Access Unit - 2 N Access Unit Configuration Manual; 5.5.6 Syslog; ;

2N Access Unit Configuration Manual
126 / 134
•
•
•
5.5.6 Syslog
The2NAccess Unitallow you to send system messages to the Syslog server including relevant
information on the device states and processes for recording, analysis and audit. It is
unnecessary to configure this service for common2NAccess Unitoperation.
List of Parameters
Send Syslog Messages– enable sending of system messages to the Syslog server. Make
sure that the server address is set correctly.
Server Address– set the IP/MAC address of the server on which the Syslog application is
running.
Severity Level–set the severity level of the messages to be sent.Debug 1–3 level setting
is only recommended to facilitate troubleshooting for the Technical Support department.