3.
Do one of the following:
l
Select Ping, then enter the desired IP address or URL in the Ping IP or URL field.
l
Select Trace Route, then enter the desired IP address or URL in the Trace Route IP or URL field.
4.
Select Start.
The screen displays the network status information.
Rebooting Your Phone
The improper operation may cause malfunction. If the malfunction occurs, your system administrator may ask you
to
reboot your phone.
Procedure
1.
Swipe left or right to go to the second idle screen.
2.
Go to Settings > Basic Settings > Reboot > Reboot.
The phone prompts you to reboot the phone or not.
3.
Select OK.
Tip
: You can also long press the * key on the keypad when the phone is idle to reboot the phone.
Resetting to Factory Settings
When some issues occur on your phone and you have tried all troubleshooting suggestions but still do not
solve
the problem, you can reset your phone to factory configurations.
This operation will delete all your personal configuration settings and reset all settings to the factory defaults.
Check with your system administrator if the personalized settings are kept before resetting your phone to factory
set-
tings.
Procedure
1.
Swipe left or right to go to the second idle screen.
2.
Go to Settings > Advanced Settings (default password: admin) > Reset Config.
2. Select Reset to Factory Settings.
The phone prompts you to reset the setting or not.
3. Select OK.
The phone begins resetting.
Tip
: You can also long press the Redial key when the phone is idle.
After reset, the screen prompts “Welcome Initializing…Please wait”.
The phone will be reset successfully after startup.
Note
: Reset of your phone may take a few minutes. Do not power off until the phone has started up successfully.
Updating the Phone Configuration
Your system administrator may ask you to update the configuration for your phone to apply any changes to
system settings, which you can do without restarting it.
Procedure
1.
Swipe left or right to go to the second idle screen.
2.
Go to Settings > Basic Settings > Update Configuration.
To Next Page
Loading...
