Rejecting Calls with DND on a Specific Line
By default, the DND feature applies to all lines on your phone. Your system administrator can change the DND
mode to Custom so that you can enable DND for specific lines.
Before You Begin
The DND mode is set to Custom. Check with your system administrator if the DND on code or off code is
required. If
required, get it from your system administrator.
Procedure
1.
Do one of the following:
l
Swipe down from the top of the screen and tap DND.
l
Swipe left or right to go to the second idle screen, and then go to Settings > Features > DND.
2.
Select the desired line.
3.
Turn on DND.
4.
(Optional.) Enter the DND on code or off code respectively in the On Code or Off Code field.
5.
Tap .
The DND icon appears on the desired line.
If you activate DND on the default line, the DND icon will appear both on the line and in the status bar.
And the
phone prompts you that DND is enabled.
Tip
: Before selecting a line, you can tap >
All On
to activate DND for all lines.
Deactivating DND
You can deactivate DND when you are ready to resume receiving calls again.
Procedure
1. Swipe left or right to go to the second idle screen.
2. Go to Settings > Features > DND.
3.
(Optional.) If the DND is activated on a specific line, select the desired line.
4.
Turn off DND.
5.
Tap .
The DND icon disappears from the status bar.
Tip
: To deactivate DND quickly, tap the
Exit DND mode.
when the phone is idle. You can also swipe down from the top
of
the screen to enter the control center and then tap
DND
to deactivate DND.
To Next Page
Loading...
Need help?
General