2N D7A - Setting up a Network Conference; Call Recording; Recording a Call

64
Setting Up a Network Conference
You can set up a network conference with multiple parties.
Procedure
1.
Place a call to the first party.
2.
Select Conference to place a new call.
Select Invite.
The active call is placed on hold.
3.
Dial the second party’s number.
4.
Repeat the above steps until you add all parties.
The conference is set up after the intended parties answer the call.
Note : The Procedures for setting up a network conference call on specific servers may be different from the
introduction above. Contact your system administrator for more information.
Call Recording
You can record up to 12 hours in one file. By default, the recorded files are saved in the internal SD card.
But if there is a USB flash drive connected to the rear USB port of your phone, the recorded files will be saved
in the storage device according to the priority: USB flash drive > internal SD card.
Recording using a USB flash drive is not available by default. Contact your system administrator for enabling
this feature for you.
Topics
Recording a Call
Recording a Conference
Setting a Mark When Recording a
Call Stopping a Recording
Checking Storage Space
Recording a Call
You can record the important parts during an active call.
Important : Before call recording, especially those involving PSTN, it is necessary to know about the rules and restrictions of
call recording in the country where you are.
It is also very important to inform all the call parties that you are recording and ask for their consent before recording the
con- versation.
Procedure
1. During a call, swipe the soft key area left and then select Record.
Select More > Record.
The phone screen displays a recording icon and recording duration.