3D Systems ProX DMP320 User Manual

533D SYSTEMS, INC.
4. Lower the build platform until the top of the printing plate matches
the exact height of the module, use a block to check the height.
5. To adjust build platform use the arrows in the Manual operation
screen.
6. Remove the recoater housing from the recoater bridge by
releasing 2 bolts.
7. Place new silicone strip in the recoater housing. Tighten all the
bolt and ensure the silicone strip is xed.

3D Systems ProX DMP320 Specifications

General

Brand	3D Systems
Model	ProX DMP320
Category	3D Printers
Language	English