ABB AC 800M

Communication Related Parameters Section 4 Configuration
128 9ARD000014-600 A
Strobe Connection
The Strobe Connection parameters in the hardware editor are described in Table 21.
Upon modification of editable parameters, the connection between LD 800DN and
all DeviceNet slaves configured under it, stops momentarily.
Inhibit Time 1 ms Int Editable This is the new data production inhibit time. This is
the rate at which the slave produces the data even
if it has a new value before this time.
COS
Connection
Enabled
Depends
on the
device
support
as stated
in its
EDS file.
Enum Editable Enable or disable the connection. If enabled,
linking device communicates with the device over
the COS connection
Values are: Enabled and Disabled.
Conn COS
InputSize
Depends
on the
device
support
as stated
in its
EDS file.
Int Read Only Number of bytes of data that gets transferred from
the device to the linking device over the COS
connection.
Conn COS
OutputSize
Depends
on the
device
support
as stated
in its
EDS file.
Int Read Only Number of bytes of data that gets transferred from
linking device to the device over the COS
connection.
Table 20. COS Connection Parameters (Continued)
Parameter
Default
Value
Type
Read Only/
Editable
Description