ABB AC 800M

Appendix B Troubleshooting CI873 Log Entries Configuration Error
9ARD000014-600 A 255
18 An attempt was made to
write to a write-once
medium that has
already been written,
or to modify a value
that cannot be changed
once established
Configuration of certain
parameters are not allowed
when the device is in run or
connected state. Ensure that
the device is in right state.
EtherNet/IP/DeviceNet
19 An invalid reply is
received (e.g. reply
service code does not
match the request
service code, or reply
message is shorter
than the minimum
expected reply size).
Invalid reply is received from
the slave device wither for the
configuration or connection
request. Contact the device
vendor.
EtherNet/IP/DeviceNet
20 Invalid Vendor Id or
Product Code specified
in the Key segment
Check the EDS file for the
correctness. Ensure that the
right EDS file is used. It can be
that device configured in
control builder is different from
the device physically available.
EtherNet/IP/DeviceNet
21 Invalid Product Type
specified in the Key
segment
Check the EDS file for the
correctness. Ensure that the
right EDS file is used. It can be
that device configured in
control builder which is
different from the device
physically available.
EtherNet/IP/DeviceNet
Table 43. Configuration Error (Continued)
Sl
No
Message in CI873 Log Description
Applicability based on
device classification