100 Control panels
IO settings mode
In the IO settings mode, you can:
• check the parameter settings related to any I/O terminal
• edit the parameter setting. For example, if “1103: REF1” is listed under Ain1
(Analog input 1), that is, parameter 1103
REF1 SELECT has value AI1, you can
change its value to eg AI2. You cannot, however, set the value of parameter 1106
REF2 SELECT to AI1.
• start, stop, change the direction and switch between local and remote control.
How to edit and change parameter settings related to I/O terminals
Step Action Display
1. Go to the Main menu by pressing if you are in the
Output mode, otherwise by pressing repeatedly until
you get to the Main menu.
2. Go to the IO settings mode by selecting IO SETTINGS
on the menu with keys and , and pressing
.
3. Select the I/O group, eg DIGITAL INPUTS, with keys
and , and press . After a brief pause, the
display shows the current settings for the selection.
4. Select the setting (line with a parameter number) with
keys and , and press .
5. Specify a new value for the setting with keys and
.
Pressing the key once increments or decrements the
value. Holding the key down changes the value faster.
Pressing the keys simultaneously replaces the displayed
value with the default value.
6. • To save the new value, press .
• To cancel the new value and keep the original, press
.
PARAMETERS
ASSISTANTS
CHANGED PAR
EXIT
ENTER
00:00
LOC
MAIN MENU 1
DIGITAL INPUTS (DI)
ANALOG INPUTS (AI)
RELAY OUTPUTS (ROUT)
ANALOG OUTPUTS (AOUT)
PANEL
EXIT SEL
00:00
LOC
IO SETTINGS 1
-DI1-
1001:START/STOP (E1)
-DI2-
1001:DIR (E1)
-DI3-
EXIT
00:00
LOC
IO SETTINGS
1001 EXT1 COMMANDS
CANCEL SAVE
00:00
LOC
[2]
DI1,2
PAR EDIT
1001 EXT1 COMMANDS
CANCEL
SAVE
00:00
LOC
[3]
DI1P,2P
PAR EDIT
-DI1-
1001:START PLS (E1)
-DI2-
1001:STOP PLS (E1)
-DI3-
EXIT
00:00
LOC
IO SETTINGS
To Next Page
Loading...
