Application macros 103
Summary of the I/O connections of the application macros
The following table gives the summary of the default I/O connections of all application
macros.
Input/
output
Macro
ABB
standard
3-wire Alternate Motor
potentiom.
Hand/
Auto
PID
control
PFC
c
ontrol,
SPFC
c
ontrol
AC500
Moodbus
AI1
(0…10 V)
Freq. ref. Freq. ref. Freq. ref. - Freq. ref.
(Hand)
Freq. ref.
(Hand) /
Proc. ref.
(PID)
Ext. ref.
1 (Hand)
/ Ext. ref.
2 (PID/
PFC)
Freq. ref.
AI2 (0…
20 mA)
- - - - Freq. ref.
(Auto)
Process
value
Process
value
-
AO Output
freq.
Output
freq.
Output
freq.
Output
freq.
Output
freq.
Output
freq.
Output
freq.
Output
freq.
DI1 Stop/
Start
Start
(pulse)
Start
(fwd)
Stop/Start Stop/
Start
(Hand)
Stop/
Start
(Hand)
Stop/
Start
(Hand)
Stop/
Start
DI2 Fwd/Rev Stop
(pulse)
Start (rev) Fwd/Rev Fwd/Rev
(Hand)
Hand/
PID
Hand/
PID,PFC
Fwd/Rev
DI3 Const.
speed
input 1
Fwd/Rev Const.
speed
input 1
Freq. ref.
up
Hand/Au
to
Const.
speed 1
Interlock Const.
speed
input 1
DI4 Const.
speed
input 2
Const.
speed
input 1
Const.
speed
input 2
Freq. ref.
down
Fwd/Rev
(Auto)
Run
enable
Interlock Const.
speed
input 2
DI5 Ramp
pair
selection
Const.
speed
input 2
Ramp
pair
selection
Const.
speed 1
Stop/
Start
(Auto)
Stop/
Start
(PID)
Stop/
Start
(P
ID/
PFC)
Ramp
pair
selection
RO Fault (-1) Fault (-1) Fault (-1) Fault (-1) Fault (-1) Fault (-1) PFC Fault (-1)
DO Fault (-1) Fault (-1) Fault (-1) Fault (-1) Fault (-1) Fault (-1) PFC
control:
Fault (-1)
SPFC
control:
PFC
Fault (-1)
To Next Page
Loading...
