74 Control panels
Output mode
In the Output mode, you can:
• monitor actual values of up to three group 01 OPERATING DATA signals, one
signal at a time
• start, stop, change the direction and switch between local and remote control.
You can enter the Output mode by pressing until the display shows text OUTPUT
at the bottom.
The display shows the value of one group 01
OPERATING DATA signal. The unit is shown on the
right. Page 77 tells how to select up to three signals to
be monitored in the Output mode. The table below
shows how to view them one at a time.
How to browse the monitored signals
Step Action Display
1. If more than one signals have been selected to be
monitored (see page 77), you can browse them in
the Output mode.
To browse the signals forward, press key
repeatedly. To browse them backward, press key
repeatedly.
To Next Page
Loading...
