192 Actual signals and parameters
1502 AO1
CONTENT MIN
Defines the minimum value for the signal selected with
parameter 1501 AO1 CONTENT SEL.
AO minimum and maximum correspond to the 1504
MINIMUM AO1 and 1505 MAXIMUM AO1 settings as
follows:
-
x…x Setting range depends on the parameter 1501 AO1
CONTENT SEL setting.
-
1503 AO1
CONTENT
MAX
Defines the maximum value for the signal selected with
parameter 1501 AO1 CONTENT SEL. See the figure for
parameter 1502 AO1 CONTENT MIN.
-
x…x Setting range depends on the parameter 1501 AO1
CONTENT SEL setting.
-
1504 MINIMUM AO1 Defines the minimum value for the analog output signal AO.
See the figure for parameter 1502 AO1 CONTENT MIN.
0.0 mA
0.0…20.0 mA Minimum value 1 =
0.1 mA
1505 MAXIMUM
AO1
Defines the maximum value for the analog output signal AO.
See the figure for parameter 1502 AO1 CONTENT MIN.
20.0 mA
0.0…20.0 mA Maximum value 1 =
0.1 mA
1506 FILTER AO1 Defines the filter time constant for analog output AO, ie the
time within which 63% of a step change is reached. See the
figure for parameter 1303 FILTER AI1.
0.1 s
0.0…10.0 s Filter time constant 1 = 0.1 s
16 SYSTEM
CONTROLS
Parameter view, Run enable, parameter lock etc.
1601 RUN ENABLE Selects a source for the external Run enable signal. NOT SEL
NOT SEL Allows the drive to start without an external Run enable
signal.
0
DI1 External signal required through digital input DI1. 1 = Run
enable. If Run enable signal is switched off, the drive does
not start or coasts to stop if it is running.
1
DI2 See selection DI1.2
DI3 See selection DI1.3
DI4 See selection DI1.4
DI5 See selection DI1.5
All parameters
No. Name/Value Description Def/FbEq
1505
1504
1502 1503
1505
1504
1503 1502
AO
content
AO (mA)
AO (mA)
AO
content
To Next Page
Loading...
