204 Actual signals and parameters
DI1 Digital input DI1.
1 = Motor heating is On.
0 = Motor heating is Off.
1
DI2 See selection DI1.2
DI3 See selection DI1.3
DI4 See selection DI1.4
DI5 See selection DI1.5
COMM Serial communication as the control for motor heating. 7
ON Motor heating active (during stop) 8
DI1(INV) Inverted digital input DI. 0 = Motor heating On 1 = Motor
heating Off.
-1
DI2(INV) See selection DI1(INV).-2
DI3(INV) See selection DI1(INV).-3
DI4(INV) See selection DI1(INV).-4
DI5(INV) See selection DI1(INV).-5
22 ACCEL/DECEL Acceleration and deceleration times
2201 ACC/DEC 1/2
SEL
Defines the source from which the drive reads the signal
that selects between the two ramp pairs,
acceleration/deceleration pair 1 and 2.
Ramp pair 1 is defined by parameters 2202…2204.
Ramp pair 2 is defined by parameters 2205…2207.
DI5
NOT SEL Ramp pair 1 is used. 0
DI1 Digital input DI1. 1 = ramp pair 2, 0 = ramp pair 1. 1
DI2 See selection DI1.2
DI3 See selection DI1.3
DI4 See selection DI1.4
DI5 See selection DI1.5
COMM Fieldbus interface as the source for ramp pair 1/2 selection,
ie Control word 0301 FB CMD WORD 1 bit 10. The Control
word is sent by the fieldbus controller through the
embedded fieldbus (Modbus) to the drive. For the Control
word bits, see section DCU communication profile on page
307.
Note: This setting applies only for the DCU profile.
7
DI1(INV) Inverted digital input DI1. 0 = ramp pair 2, 1 = ramp pair 1. -1
DI2(INV) See selection DI1(INV).-2
DI3(INV) See selection DI1(INV).-3
DI4(INV) See selection DI1(INV).-4
DI5(INV) See selection DI1(INV).-5
All parameters
No. Name/Value Description Def/FbEq
To Next Page
Loading...
