ABB ACS310 - Input Phase Loss; Operation Limits; Settings; Pre-Programmed Faults

136 Program features
Settings
Parameter 3023 WIRING FAULT
 Input phase loss
Input phase loss protection circuits supervise the input power cable connection status
by detecting intermediate circuit ripple. If a phase is lost, the ripple increases.
Settings
Parameter 3016 SUPPLY PHASE
Pre-programmed faults
 Overcurrent
The overcurrent trip limit for the drive is 325% of the drive nominal current.
 DC overvoltage
The DC overvoltage trip limit is 420 V (for 200 V drives) and 840 V (for 400 V drives).
 DC undervoltage
The DC undervoltage trip limit is adaptive. See parameter 2006 UNDERVOLT CTRL.
 Drive temperature
The drive supervises the IGBT temperature. There are two supervision limits: Alarm
limit and fault trip limit.
 Short circuit
If a short circuit occurs, the drive does not start and a fault indication is given.
 Internal fault
If the drive detects an internal fault, the drive is stopped and a fault indication is given.
Operation limits
The drive has adjustable limits for output frequency, current (maximum) and DC
voltage.
 Settings
Parameter group 20 LIMITS
Aotewell Ltd
www.aotewell.com
Industry Automation
HongKong|UK|China
sales@aotewell.com
+86-755-8660-6182