ABB ACS380 Series - Page 21

Control panel 21
Motor Control
1. Start mode - Const time, Automatic
2. Stop mode - Coast, Ramp, DC hold
3. Acceleration time
4. Deceleration time
5. Maximum allowed speed
6. Maximum allowed current
7. Minimum allowed speed
Motor Control: Start modes
1. Const time
2. Automatic
Motor Control: Stop modes
1. Coast
2. Ramp
3. DC hold
Control macros The control macros available depends on the option module
installed.
1. ABB standard (2-wire)
2. ABB limited (2-wire)
3. Alternate
4. Motor potentiometer
5. PID
6. Modbus RTU
7. PROFIBUS (Node number or Station ID)
8. PROFINET IO - for FENA-21 module
9. EthernetIP - for FENA-21 module (Static IP, Subnet mask)
10.Modbus TCP - for FENA-21 module
11.EtherCAT
12.CANopen