138 Electrical installation
Connecting a PC
To be able to connect a PC to the drive, you need an assistant control panel (ACS-
AP-I, ACS-AP-S or ACS-AP-W). It is also possible to use CCA-01 configuration
adapter.
Connect a PC to the drive with a USB data cable (USB Type A <-> USB Type Mini-B)
as follows:
1. Lift the USB connector cover from bottom upwards.
2. Put the USB cable Mini-B plug in the control panel USB connector.
3. Put the USB cable A-plug in the USB connector of the PC (3a). The panel
displays text “USB connected” (3b).
Note: Panel keys cannot be used when a USB data cable is connected to the panel.
For information on using the Drive composer PC tool, see Drive composer PC tool
user's manual (3AUA0000094606 [English]).
You can connect a remote ACS-AP-I, ACS-AP-S or ACS-AP-W control panel to the
drive, or to chain the control panel or a PC to several drives on a panel bus with a
CDPI-01 communication adapter module. See CDPI-01 communication adapter
module user's manual (3AXD50000009929 [English]).
To Next Page
Loading...
