ABB ACS580-01 - Primary Settings Menu

Mechanical installation 59
 Installing the drive vertically, frame R5
1. Mark the hole locations using the mounting template included in the package. Do
not leave the mounting template under the drive. The drive dimensions and hole
locations are also shown in the drawings in chapter Dimension drawings on page
203.
2. Drill the mounting holes.
3. Insert fixing anchors or plugs into the holes. Start the two upper bolts and the two
lowest bolts into the anchors or plugs.
Drive the bolts long enough into the wall to make them carry the weight of the
drive.
c
a
d
e
b
1
R5 IP21 (UL Type 1)
R5 IP55 (UL Type 12)
mm in mm in
a 612 24.09 612 24.09
b 581 22.87 581 22.87
c 1606.301606.30
d > 200 7.9 200 7.9
e > 200 7.9 200 7.9
R5 IP21 (UL Type 1)
R5 IP55 (UL Type 12)
kg lb kg lb
28.3 62.4 28.6 63.1
×2
×2
×2
×2
×2
3 2
×6