ABB ACS580-01 - Sizing

162 Technical data
 Sizing
Drive sizing is based on the rated motor current and power. To achieve the rated
motor power given in the table, the rated current of the drive must be higher than or
equal to the rated motor current. Also the rated power of the drive must be higher
than or equal to the rated motor power. The power ratings are the same regardless of
the supply voltage within one voltage range.
Note: The ratings apply at ambient temperature of 40 °C (104 °F) for I
N
. Above
theses temperatures derating is required.
Note: The DriveSize dimensioning PC tool available from ABB
(http://new.abb.com/drives/software-tools/drivesize
) is recommended for selecting
the drive, motor and gear combination.
I
Hd
Maximum current with 150% overload, allowed for one minute every ten minutes
1)
Maximum current with 130% overload, allowed for one minute every ten
minutes
2)
Maximum current with 125% overload, allowed for one minute every ten
minutes
P
Hd
Typical motor power in heavy-duty use (150% overload)