ABB ACS580-01 - Layout

Operation principle and hardware description 29
Layout
Frames R1…R2
The layout of a frame R1 drive is presented below. The main structure of frame R2 is
similar to R1. IP55 frames are also slightly different from IP21 frames, for example,
IP21 front cover has two parts while IP55 front cover only has one part.
1 Mounting points (4 pieces)
2 Cover: upper part (2a), lower part (2b)
3Cover screw
4 Cable/conduit box
5 Control panel
6 Control panel connection
7 Cold configuration connection for CCA-01
7 Power OK and Fault LEDs. See section
LEDs on page 156.
8 I/O connections. See section External
control connection terminals, frames
R1…R5 on page 35.
9 Varistor grounding screw (VAR).
See Checking the compatibility with IT
(ungrounded) and corner-grounded TN
systems on page 91.
10 EMC filter grounding screw (EMC).
See Checking the compatibility with IT
(ungrounded) and corner-grounded TN
systems on page 91.
11 Place for storing the removed VAR screw
12 Place for storing the removed EMC screw
13 Input power connection (L1, L2, L3),
motor connection (T1/U, T2/V, T3/W) and
brake connection (R-, R+)
14 PE connection (power line)
15 Grounding connection (motor)
16 Additional grounding connection
17 Stripping length (8 mm) checker
18 Cable entry
19 Main cooling fan
20 Cable tie mounts for I/O cables
21 Auxiliary cooling fan connector
6
7
8
11
8
18
1
5
1
2a
PE
10
20
R1 IP21
14
15
20
21
1
16
17
3
12
2b
4
19
9
13