Technical data 201
China RoHS marking
The People’s Republic of China Electronic Industry Standard (SJ/T 11364-2014)
specifies the marking requirements for hazardous substances in electronic and
electrical products. The green mark is attached to the drive to verify that it does not
contain toxic and hazardous substances or elements above the maximum
concentration values, and that it is an environmentally-friendly product which can be
recycled and reused.
RCM marking
See the type designation label for the valid markings of your drive. Regulatory
Compliance (RCM) Mark is required in Australia and New Zealand. A RCM mark is
attached to the drive to verify compliance with the relevant standard (IEC/EN 61800-
3:2004 – Adjustable speed electrical power drive systems – Part 3: EMC product
standard including specific test methods), mandated by the Trans-Tasman
Electromagnetic Compatibility Scheme. For fulfilling the requirements of the standard,
see section Compliance with IEC/EN 61800-3:2004 on page 382. The declaration of
conformity (3AXD10000493117) is available on the Internet. See section Document
library on the Internet on the inside of the back cover.
WEEE marking
The drive is marked with the wheelie bin symbol. It indicates that at the end of life the
drive should enter the recycling system at an appropriate collection point and not
placed in the normal waste stream. See section Disposal on page 194.
EAC marking
EAC marking is required in Russia, Belarus and Kazakhstan. The EAC certificate of
conformity (3AXD10000312900) is available on the Internet. See section Document
library on the Internet on the inside of the back cover.
Disclaimer
The manufacturer shall have no obligation with respect to any product which (i) has
been improperly repaired or altered; (ii) has been subjected to misuse, negligence or
accident; (iii) has been used in a manner contrary to the manufacturer's instructions;
or (iv) has failed as a result of ordinary wear and tear.
Cyber security disclaimer
This product is designed to be connected to and to communicate information and
data via a network interface. It is Customer's sole responsibility to provide and
continuously ensure a secure connection between the product and Customer network
To Next Page
Loading...
