ABB ACS580-01 - External Control Connection Terminals, Frames R6

36 Operation principle and hardware description
 External control connection terminals, frames R6…R9
The layout of the external control connection terminals of frames R6…R9 is shown
below.
WARNING! Do not connect the +24 V AC cable to the control board ground when the
control board is powered using an external 24 V AC supply.
2
Description
X1 Analog inputs and outputs
X2 Aux. voltage output
X3 Digital inputs
X4 Safe torque off connection
X5 Connection to embedded EIA-
485 fieldbus adapter module
X6 Relay output 3
X7 Relay output 2
X8 Relay output 1
X10 External +24 V AC/DC input
connection
X12 Panel connection
X13 Option slot 1 (fieldbus adapter
modules)
X14 Option slot 2 (I/O extension
modules)
X16 Auxiliary fan 1 connection
X17 Auxiliary fan 2 connection
S4, S5 Termination switch (S4), bias
resistor switch (S5), see section
Switches on page 120
1 Panel port (control panel
connection)
2 Cold configuration connection.
This connector is used with the
CCA-01 configuration adapter.
3 Power OK and Fault LEDs. See
section LEDs on page 156.
R6…R9
X2
X4
X13
1
3
X8
X7
X6
X10
X5
S4, S5
X17X16
X14
X1:1…3
X1:4…6
X1:7…9
X3:1…3
X3:4…6
X12