Electrical installation 99
Motor cable
4. Cut an adequate hole into the rubber grommet. Slide the grommet onto the cable.
5. Prepare the ends of the cable as illustrated in the figure. In frames R1 and R2
there are markings on the drive frame near the power cable terminals helping you
to strip the wires to the correct length of 8 mm. If you use aluminum cables, put
grease to the peeled aluminum cable before connecting it to the drive. Two
different motor cable types are shown in the figures (6a, 6b). Note: The bare
shield will be grounded 360 degrees.
6. Slide the cable through the hole in the cable entry and attach the grommet to the
hole.
To Next Page
Loading...
