Mechanical installation
Stand assembly
2-8 3HEA 800 970-001 Rev. D, Mars 2006
Installation and operation
2.3 Stand assembly
2.3.1 Procedure
The track motion should be assembled as described in the procedure below.
Detailed descriptions of each stage can be found further on in the manual.
Action
1. Assemble the stand modules according to "Positioning the stand" on page 2 - 9.
2. Assemble the linear guides according to "Fitting the linear guides" on page 2 - 11.
3. Assemble the gear racks according to "Installing gear racks" on page 2 - 20.
4. Secure the stand to the foundation according to "Securing the stand to the foundation"
on page 2 - 22.
5. Fit the protective guards and cover plates according to "Fitting the cover plates" on
page2-22.
6. Fit the cable tray according to "Fitting the cable tray and manipulator" on page 2 - 25.
The module's fish bolts are only required on prefitted modules up to six meters that are to be
lifted as a single unit.
If the track motion consists of more modules, these should not be fitted using fish bolts.
See the illustration below.
stativmodul IRC5.wmf
Figure 5 Stand module
To Next Page
Loading...
