Maintenance instructions
Refilling the lubricant
3HEA 800 970-001 Rev. D, Mars 2006 3-5
Maintenance
2.1.8 Refilling the lubricant
If the track motion is equipped with an automatic lubrication system, the system
must be refilled every third month or when empty.
Refilling is accomplished by changing the grease injector.
Changing grease injectors
If an electromechanical grease injector is empty, the entire grease injector is
replaced as follows:
Only use grease injectors with 3-month or less capacities.
Action Info/Illustration
1. Remove the empty grease injector.
2. Remove the protective cover on the new
grease injector.
3. Press the activation pin fully; see
position 2.
4. Fit the new grease injector.
2
1
To Next Page
Loading...
