Commissioning
Checking the work space
3HEA 800 970-001 Rev. D, Mars 2006 2-47
Installation and operation
4.4.3 Checking the work space
Checking the work space
Run the system manually using the joystick and check that:
• It can be run in both directions.
• Both end positions can be reached.
4.4.4 Check for abnormal wear and noise
Abnormal noise when the track motion is put in service may be due to incorrect
assembly of the linear guides or gear racks, or because the gear play meshing
pressure needs adjustment.
Linear guide joints
Check and adjust the linear guides joints as required according to "Fitting the linear
guides" on page 2 - 11.
Gear rack joints
Check and adjust the gear racks joints as required according to "Installing gear
racks" on page 2 - 20.
The track motion's work space must be inspected before the system is put in service.
To Next Page
Loading...
