Commissioning
Activating the automatic lubrication system
3HEA 800 970-001 Rev. D, Mars 2006 2-41
Installation and operation
4.3 Activating the automatic lubrication system
If the track motion is equipped with an automatic lubrication system, it must be
activated. These may be of different types – automatic lubrication systems with
grease injectors or central lubrication systems with timers. These are activated in
different ways.
4.3.1 Activating grease injectors
The grease injectors in the automatic lubrication system are not activated on
delivery. When the grease injectors are activated, they will continuously and
automatically apply the correct amount of grease for three months.
Activate the grease injectors as follows:
Action Info/Illustration
1. Locate the grease injectors (5 units).
2. Press the activation pin fully on each
grease injector.
3. Listen for the injector's grease motor to
start (it takes about 10 seconds after the
pin has been pressed in).
1
1
1
2
To Next Page
Loading...
