Mechanical installation
Positioning the stand
3HEA 800 970-001 Rev. D, Mars 2006 2-9
Installation and operation
2.3.2 Positioning the stand
Follow the directions below to position the stand modules:
Action Info/Illustration
1. Position the leveling plates on one side of
the intended installation location.
Position the bottom plates for the cable
tray modules on the other side of the
installation location.
The spacing between the centers of the
plates should be 1000 mm.
2. Position the first stand module, with
carriage, precisely at the intended
installation location.
3. Adjust the module according to "Adjusting
the level" on page 2 - 10 so that it is
aligned within the given tolerance.
If the track motion is to consist of several
modules, continue to step 4. Otherwise
continue with "Fitting the linear guides" on
page2-11.
4. Position the next module in the direction of
travel adjacent to the newly aligned
module.
5. Adjust according to "Adjusting the level"
on page 2 - 10 so that this and the
previous module's machined surfaces
(for linear guide and gear rack) are flat and
level with each other.
If more modules are to be fit, repeat steps
3 and 4. Otherwise continue with "Fitting
the linear guides" on page 2 - 11.
1
0
0
0
x
N
1
0
0
0
±
1
m
m
1
0
0
0
To Next Page
Loading...
