Mechanical installation
Fit the side plates
3HEA 800 970-001 Rev. D, Mars 2006 2-23
Installation and operation
2.3.9 Fit the side plates
Follow the instructions below to fit the side plates.
Action Info/Illustration
1. Fit the angle brackets on the ground
plates.
2. Fit the side covers by pushing them
down between the beam and angle
bracket. Tighten the retaining screws in
the angle brackets.
3. Apply tape over all joints in the side
guard.
4. Continue with "Fitting the cable tray" on
page 2 - 25
1
2
3
To Next Page
Loading...
