Description
Note
To enable this function, you need to select the checkbox for this function in the recipe configuration
page.
xx1900001568
ConveyorUp-
perLimit
Note
The UpperLimit/LowerLimit function in the Tunning window has a slight delay.
UpperLimit is the limit form where robot considers an item target as lost on the work area in End
Y.The distance is calculated in milli-meters from the center of the robot. The range is positive if
the limit is beyond the center of the robot, relative to the moving vertical direction of the convey-
or.Make sure that the enter limit can be reached by the robot.
Continues on next page
164 Application manual - PickMaster® Twin - PowerPac
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
4 Working with PickMaster PowerPac
4.2.12 Simulation
Continued
To Next Page
Loading...
