Description
Note
To enable this function, you need to select the checkbox for this function in the recipe configuration
page.
xx1900001568
Conveyor-
LowerLimit
Note
The UpperLimit/LowerLimit function in the Tunning window has a slight delay.
LowerLimit is the limit form where robot starts to execute item targets on the work area in Start Y.
The distance is calculated in milli-meters from the center of the robot. The range is positive if the
limit is beyond the center of the robot, relative to the moving vertical direction of the conveyor.If
the y coordinate value of the item's position is greater than the UpperLimit, the robot will not grab
the item. So when the tracked item passes beyond this limit it will be dropped. This limit must be
chosen well within the maximum reach of the robot.
Continues on next page
Application manual - PickMaster® Twin - PowerPac 165
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
4 Working with PickMaster PowerPac
4.2.12 Simulation
Continued
To Next Page
Loading...
Need help?
General
