DescriptionTypeError code
The line file is invalid and cannot be opened.Error4209
Failed to load resources for the selected language. The default
language (English) will be used instead
Error4210
A notification about the total number of picks done by a robot
until the project was stopped.
Status4211
Failed to remove the line file. The file must be removed
manually.
Error4212
Failed to find the html help file for the selected language.
Make sure the "Application manual xxx.chm" file is in the
Documentation folder in the PickMaster folder.
Warning4213
An attempt to open a file not recognized by PickMaster.Error4216
No time synchronization service available.Error4217
Reason: The PickMaster Time Synchronization Service
might not be properly installed or not started.
Solution: Verify the service is installed and try to restart the
service.
Two or more network adapters are configured on the same
subnet: x.x.x
Warning4218
Refer to the user guide and review the recommended network
settings.
Attempt to start a project that is already running.Status4297
Attempt to stop a project that was not started.Status4298
A camera is currently in use by another project.Error4300
Reason: When starting a project, one of the position sources
is configured with a camera that is currently in use by another
project.
Solution: A camera can only be used in production in one
project at the same time. Reconfigure one project or run them
one at a time.
Failed to start project executionError4301
Reason: Internal error probably caused by out of memory.
Solution: Try restarting the PickMaster program.
When starting a project, a vision defined position source has
no camera defined.
Error4302
Solution: Either remove the position source or configure it
with the camera to use.
When starting a project, a position source has no work area
defined
Error4303
Solution: Either remove the position source or configure it
with the work area to use
When starting a project, a vision defined position source has
no configured vision models.
Warning4304
Solution: Either remove the position source or define which
vision models to use.
When starting a project, a predefined position source has no
object defined.
Error4305
Solution: Edit the position source and define the predefined
object to use.
Continues on next page
434 Application manual - PickMaster® Twin - PowerPac
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
7 Troubleshooting
7.5 Error codes
Continued
To Next Page
Loading...
