DescriptionItem
Sync the application program to the solution.Sync RAPID program to
station
Procedure
On the PickMaster PowerPac ribbon-tab, click Layout.
Use this procedure to add a controller:
Note
You can only add the existed controller in the system to the solution. For more
information about create controller, see Create a controller on page 75.
Note
The controller must be created before this step.
1 On the ribbon-tab, click Controller.
xx1800000845
Continues on next page
Application manual - PickMaster® Twin - PowerPac 77
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
4 Working with PickMaster PowerPac
4.2.2 Adding Controller
Continued
To Next Page
Loading...
