4 If you select a liner conveyor, in the Conveyor window, enter numbers in the
LWH Size(mm) text box to define the size of the conveyor according to your
requirements.
xx1900000574
5 If you select a circular conveyor, in the Conveyor window, enter numbers in
the RH Size(mm) text box to define the size of the conveyor according to
your requirements.
xx1900000575
6 Click Preview, the conveyor preview appears in the station view. The
conveyor position setting text box is activated.
7 In the Conveyor window, enter numbers in the Position X Y Z (mm) text box
and Orientation (deg) text boxes to define the location of the conveyor
according to your requirements.
8 In the Conveyor window, use default for the Conveyor Signal and Controller.
9 Click OK.
Application manual - PickMaster® Twin - PowerPac 87
3HAC064218-001 Revision: B
© Copyright 2021 ABB. All rights reserved.
4 Working with PickMaster PowerPac
4.2.4 Adding Conveyor
Continued
To Next Page
Loading...
