ABB SCK - Maintenance: Gas Sampling Probe 60 S; Maintenance: Probe Retractor

152 Operating instruction SCK Gas Sampling System OI/SCK-EN Rev. E
Maintenance task See … Inspection/Maintenance
intervall
as required
dayiy
weekly
twice yearly
yearly
every 2 years
Gas sampling probe 60S
 Mechanical cleaning of
probe pipe and tip
Gas sampling probe 60S: Removing
incrustations on page 184
X X

Clean or replace outlet filter
Gas sampling probe 60S: Cleaning or
replacing the outlet filter on page 186
X X
 Replace O-ring seals on the
filter unit
Gas sampling probe 60S: Replacing
the seal set on page 189
X
Maintenance task See … Inspection/Maintenance
intervall
as required
dayiy
weekly
twice yearly
yearly
every 2 years
Probe retractor
 Check filter muffler
Probe retractor: Checking and replac-
ing the filter muffler on page 193
X

Check oil level in oiler in
pneumatic box and chang-
ing the quantity of oil deliv-
ered
Probe retractor: Checking and toppin
g
up the oiler on page 195
X

Check and if necessary
tighten drive chain
Probe retractor: Checking and tighten-
ing the drive chain on page 198
X X

Check and if necessary
adjust the filter/pressure
control combination or re-
place filter
Probe retractor: Checking fil-
ter/pressure control combination on
page 191
X

Check condition of bellows
Probe retractor: Checking the bellows
on page 207
X
 Check and, if necessary,
adjust the position of the
probe
Probe retractor: Checking and, if nec-
essary, adjusting the position of the
probe on page 200
X
 Check position indicator on
the retractor and, if neces-
sary, re-align
Probe retractor: Checking and, if nec-
essary, adjusting the position indica-
tor (probe end position) on page 204
X X