78 SensyMaster FMT430, FMT450 THERMAL MASS FLOWMETER | OI/FMT430/450-EN REV. B
… 8 Commissioning
… Parameterization via the menu function Easy Setup
Dig.Out 51/52 Mode”
has been selected.
40. Use to call up the edit mode.
41. Using / , select the desired process value for
frequency output 51 / 52.
42. Confirm the selection with .
Dig.Out 51/52 Mode”
has been selected.
43. Use to call up the edit mode.
44. Using / set the frequency for 100 % of the flow rate.
45. Confirm the selection with .
Dig.Out 51/52 Mode”
has been selected.
46. Use to call up the edit mode.
47. Using / set the frequency for 0 % of the flow rate.
48. Confirm the selection with .
Dig.Out 51/52 Mode”
has been selected.
49. Use to call up the edit mode.
50. Using / , select the desired function for binary output
51 / 52.
51. Confirm the selection with .
Only if an appropriate plug
-in card is
52. Use to call up the edit mode.
53. Use / to select the desired operating mode (Off,
Binary) for digital output V1 / V2 or V3 / V4.
54. Confirm the selection with .
Dig.Out V1/V2 Mode or
3/V4 Mode Binary has been
selected and an appropriate plug
-in
55. Use to call up the edit mode.
56. Use / to select the desired function for binary output
V1 / V2 or V3 / V4.
57. Confirm the selection with .
Select the application
58. Use to call up the edit mode.
59. Use / to select the desired application.
60. Confirm the selection with .
To Next Page
Loading...
