Adixen ASM GRAPH D+ - Page 186

D 300
General troubleshooting guide
ASM 142 - 142 D - Graph D+ GB 04081 - Edition 01 - January 2009
Symptoms
D 400
Message
autocal. required
2
Manual calibration
4
New fil #1 / #2 required
5
Filament request of f
6
Maintenance required
1
Control panel
« ! « or « i « appears at the end of line 1 on the LCD
23
No display appears on the control panel
42
Helium signal or inlet pressure analog display abnormally lit
27
Helium signal digital display flashing
24
Primary pump
No noise from the rotary vane pump
55
Abnormal noise from the rotary vane pump
56
High vacuum pump
Pump failure
52
Pump speed
53
Cell pressure
Cell pres. > 0.01 mbar
7
Cell pres. > 1e-04 mbar
8
Cell pressure safety
13
Triode safety
14
Inlet pressure
Impossible to reach the selected mode
20
Inlet pressure display does not show atmospheric pressure
16
No inlet vent (inlet vent ON requested)
17
2/4