Adixen ASM GRAPH D+ - Critical Failure; Major Fault

C 580
Fault / information indicator and display
1/6
WARNING! PRESS NEXT
...
...
...
CRITICAL FAILURE
pressure gauge fail.
SERVICE AND RESTART
GB 02465
-
Edition 03
-
September
06
Faults (cont.)
ASM 142 S and ASM 102 S special case:
• If after the start, the background is lower than the sniffer probe
clogged point:
- The “ AL ” message appears permanently on the
digital display
,
- a «!» flashing at the right end of the screen.
LEAK RA TE
COR
• This default, althought minor, is blocking. It is necessary to launch a
calibration to make it disappear .
Major fault
• W arning:
- on the digital display, “ Er ” is permanently displayed.
- a flashing message occurs on the LCD
LEAK RA TE
COR
he digital voice advises the operator of the procedure to follow .
• Result:
May prevent the leak
detector from making a vacuum test or an
autocalibration
• Message:
To read the messsage
NEXT
Note: A major fault can behave like a temporary minor fault if the
origin of the error has disappeared.
Critical failure
• W arning:
- on the digital display, “ Er ” is permanently displayed. All indicators
are turned off.
- on the LCD the clear message of a critical failure is directly
displayed.
Details are displayed on line 2 and 3.
LEAK RA TE
COR
The digital voice advises the operator of the procedure to follow .
• Result:
Complete shut down of the leak detector is required.
• Remedy:
Need the servicing of the leak
detector before starting it again.