Using
the
grease
syringe
The
grease syringe is equipped
A
with a black clip (A) and a red
clip
(
B
).
These
clips are
used
as stops
to control the amount of grease
injected into the bearing.
Greasing the front
bearing
Greasing the rear
bearing
Push
the grease syringe in
through the screw hole (1)
until it
comes
up against a stop.
1
Inject grease pushing in the
2
plunger until it
stops
at clip
B
.
Remove
the red clip
B
and
distribute the grease between the
injection points
(smooth
holes directly opposite each other: 2).
2/5
To Next Page
Loading...
