Adtech ADT-DK300A - Page 102

BZ001M056A ADT‐DK300A/400A Engraving Machine

93
Negative
Home direction is valid in mechanical home mode, that is, the system
scansthehomesignaldirectionofthemachineinthehomeprocess.

054  CircleInpUnit(mm)
Range : 0~1
Unit : mm
Authority : Operationadminorhigher
Default : 0.2
Effectivetime : Instant
Note :
Setthearcint erpolationequivalent
Ifthisvalueistoosmall,thearchashigherapproximationaccuracy,but
the computationwill be toohigh, making the pauseduring processing
obvious
andaffectingtheprocessingeffect.

055 
G73(M)LoopObligate(mm)
056 
G83(M)LoopObligate(mm)
Range : 0.1~100
Unit : mm
Authority : Operationadminorhigher
Default : 2.000
Effectivetime : Instant
Note : SetthetoolretractingamountafterQisfedinG73andG83instructions;
this parameter (default: 2mm) is set according to actual chip removal
eff ect.
057  ArcSpeedUpVal
Range : 0&1
Unit :
Authority : Operationadminorhigher
Default : 1
Effectivetime : Instant
Note :
Setarcspeedprocessingmode
As for arc split, 0 is to interpolate through time split arc, and 1 is to
interpolatethroughstepsplitarc.

