BZ001M056A ADT‐DK300A/400A Engraving Machine
102
098 Programresetreferencepointenable
Range : ON~OFF
Unit : None
Authority : Operationadminorhigher
Default : OFF
Effectivetime : Instant
Note : Set whether return to set par ameter reference point after mechanical
home, OFF is not to return to reference point, ON is to return to the
reference point after home operation.
The reference point is set in
coordinatesysteminterface.
099 Mechanicalresetreferencepointenable
Range : ON~OFF
Unit : None
Authority : Operationadminorhigher
Default : OFF
Effectivetime : Instant
Note : Set whether return to set par ameter reference point after mechanical
home, OFF is not to return to reference point, ON is to return to the
reference point after home operation.
The reference point is set in
coordinate system interface. The reference point is different from the
pointofprogramhome.Referencepoints1~4areformechanicalhome.
100 Clearcoordinatesysteminresetmode
Range : MACCoord&G54Coord
Unit : None
Authority : Operationadminorhigher
Default : MACCoord
Effectivetime : Instant
Note : Insystemoperationscreen,pressX,Y,Z,Ainresetmodeandthenpress
the Cancel key to clear the coordinates. MAC is to clear machine
coordinates,G54
is to clear programzero point, which is equivalentto
the operation of tool setting. If it is set to G54, the program home
operationistoreturntothezeropositionoftheworkpiece.
101 Zsafeheight(G54coordinates)
Range :‐9999~9999
Unit : mm
Authority : Operationadminorhigher
Default : 0
Effectivetime : Instant
Note : SetthesafepositionofZ‐axisofthemachinetool,whichcanbemachine
tool coordinates or program coordinates, and specified by 096#
parameter.
102 Asafeheight(G54coordinates)
To Next Page
Loading...
Need help?
General
